Cateye HL-EL540 [Econom Force] Bedienungsanleitung PDF herunterladen

SPECIFICATIONS

Light source ............ High-intensity white LED x 1

Battery ....................AA alkaline battery x 4

Operating time ........ Hi : Approx. 2 hours, Low : Approx. 9 hours,

Flash : Approx. 30 hours

Temperature range . . 14˚F – 104˚F (-10˚C – 40˚C)

Dimensions/weight

...

4-1/2” x 2-13/64” x 2-3/32” (114 x 56 x 53 mm)

/ 8 oz (227 g) (Including batteries)

The speciﬁ cations and design are subject to change without notice.*

BATTERY HEADLIGHT

HL-EL540

Pat. and Design Pat. Pending

EL54-120123 066640832 3

INTRODUCTION

Before using the product, please thoroughly read

this manual and keep it for future reference.

CAUTION!

Before your trip, please make sure the light is •

ﬁ rmly mounted to the bracket, it lights up, and

the light is not blocked by baggage, etc.

Mount the light unit more than 7 cm away •

from the wireless meter. When it is mounted

too close, the transmission may be affected

adversely.

This product is water-resistant under normal •

daily use and can be used in the rain. However,

do not intentionally submerge it in water.

If the light unit or parts become dirty with mud, •

etc., clean with a soft cloth which is moistened

with mild soap. Never apply paint thinner,

benzine or alcohol; damage will result.

COMPONENTS

HOW TO REPLACE BATTERY

HOW TO MOUNT

HOW TO USE

NO!

Open

., LTD.

2-8-25, Kuwazu, Higashi Sumiyoshi-

ku, Osaka 546-0041 Japan

Attn: CATEYE Customer Service

Phone : (06)6719-6863

Fax : (06)6719-6033

E-mail : [email protected]

URL : http://www.cateye.com

[For US Customers]

CATEYE AMERICA, INC.

2825 Wilderness Place Suite 1200,

Boulder CO80301-5494 USA

Phone : 303.443.4595

Toll Free : 800.5CATEYE

Fax : 303.473.0006

E-mail : [email protected]

SPARE PARTS

OPTION PARTS

CHA-2.2AH-4.8V

5338827N

FlexTight™ bracket (H-34N)

Special nickel-hydride

rechargeable battery x 4

(Ni-MH 2.2Ah GP220AAH)

UL : 5336760

UK : 5336761

EC : 5336762

AS : 5336763

JP : 5336764

ENG

LIMITED WARRANTY

2-year Warranty: Light unit only

CatEye products are warranted to be free of defects from materials

and workmanship for a period of 2 years from original purchase. If

the product fails to work during normal use, CatEye will repair or re-

place the defect at no charge. Service must be performed by CatEye

or an authorized retailer. To return the product, pack it carefully and

enclose the warranty certiﬁ cate (proof of purchase) with instruction

for repair. Please write or type your name and address clearly on the

warranty certiﬁ cate. Insurance, handling and transportation charges

to CatEye shall be borne by person desiring service. For UK and

REPUBLIC OF IRELAND consumers, please return to the place of

purchase. This does not affect your statutory rights.

Turn the lock cap on the back of the light 1

counterclockwise to remove.

Press the switch slowly, and pull out the 2

inner unit from the front.

Install the lower battery ﬁ rst. Remove the 3

upper battery ﬁ rst by pressing the arrowed

point as shown.

After replacement, check that the two rubber 4

gaskets for the inner unit are in place, place it

into the body, and ﬁ x it with the lock cap.

CAUTION!:

To pull out the inner unit from the light, be •

sure to hold the lens. Otherwise, the inner

unit may fall out and become damaged.

Do not use in combination with new and old •

batteries, or different types of batteries.

Be sure to install batteries in the correct •

direction.

Install the two rubber gaskets correctly to •

maintain waterproof features.

Remove and store batteries when you will •

not use the light for a long period of time.

Otherwise, batteries may leak liquid, which

may result in failure.

Wind the bracket strap around the handlebar, 1

and put the strap through the opening.

Screw the dial into the bracket to secure it 2

temporarily.

Insert the light unit to the bracket until it *

clicks, and adjust the beam angle.

(Refer to “HOW TO MOUNT THE LIGHT”)

Securely tighten the dial, and cut off any 3

excess bracket strap.

To remove the light unit, pull out it forward *

while pressing the button.

To re-adjust the beam angle, loosen the dial *

enough to move the bracket, and securely

tighten it after adjustment.

CAUTION!:

Be sure to tighten the dial by hand. When •

you tighten it too hard with a tool, the screw

thread may be stripped.

Check the dial and screw (*1) on the bracket •

periodically, and use them without any

loosening.

Round off the cut edge of the bracket strap •

to prevent injury.

Switch operation

(switching the lighting mode)

The ON/OFF and lighting modes are selected

using a switch.

Standard operating time

Hi : Approx. 2 hours

Low : Approx. 9 hours

Flash : Approx. 30 hours

*2 When returning from Flash to ON (Hi or Low),

it returns to the ON mode used previously.

Remaining battery capacity

When the switch (indicator) lights up, the

remaining battery level is low. Replace with

new batteries.

↔

OFF : Long press

↔

Low : Single press

Flash : Quick double press

(Flash even from OFF)

Lock cap

Inner unit

Switch

Rubber gasket

How to remove

batteries

DialRubber padBracket

Strap

Light unit

FlexTight™

bracket (H-34N)

AA alkaline

battery x4

HOW TO MOUNT THE LIGHT

Release

button

Screw

Press the lens

side of the upper

battery.

5341891

Switch (indicator)

Inhaltsverzeichnis

Seite 1 - HOW TO USE

SPECIFICATIONSLight source .... High-intensity white LED x 1Battery ......AA alkaline battery x 4Operating time ... Hi : Ap

Kommentare zu diesen Handbüchern

Keine Kommentare

Cateye HL-EL540 [Econom Force] Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Fahrräder Cateye HL-EL540 [Econom Force] herunter. CatEye HL-EL540 [Econom Force] User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Fahrräder Cateye HL-EL540 [Econom Force]